Jump to content
Electrical calibration on EMC measuring equipment

Calibration of high quality EMC measuring equipment

Testo Industrial Services mastered the special challenge of high quality, complex electrical equipment from different manufacturers with its flexible solution, on-site calibration in the customer's own laboratory at Bosch Engineering Absatt.

Bosch Engineering GmbH is a 100 percent owned subsidiary of Robert Bosch GmbH. Around 1,400 people are employed across the sites in Germany, Austria, Japan and the USA. Bosch Engineering GmbH offers developments for vehicle and engine manufacturers and specialises in the individual adaptation of Bosch large scale production technology. Testo Industrial Services has taken over the complete calibration requirement for the EMC equipment at the Abstatt headquarters.

Bosch Engineering's goal was to have its high quality EMC measurement equipment calibrated by a single independent calibration service provider. Short lead times, high quality and small measurement uncertainties at a good price were desired. One challenge was the calibration of the devices on site. Since the equipment is permanently integrated in the internal Bosch EMC laboratory, it was not possible to remove and ship test equipment.

Your advantage: Our competence

  • Calibration of the high-quality measuring/testing equipment of an EMC laboratory
  • ISO calibration according to accredited standards
  • On-site calibration in the Bosch Engineering laboratory
  • Calibration of measuring instruments of all manufacturers
  • Holistic support of the customer in the area of test equipment management

More about our services

Technicians perform on-site calibration of equipment

On-site calibration

Mobile technicians and engineers are on duty for you throughout Europe

Calibration in the electrical laboratory

Electrical measured variables

Learn more about our calibration of electrical measurands

Service portfolio for Testo Industrial Services GmbH

Service portfolio

Your partner for calibration, gauge management, qualification and validation